The BedRug VanTred Custom Mat, # VTNV11, is custom cut to fit in your 2016 Nissan NV 3500 van. The mat is cut to fit in between the wheel wells of the van, however, the openings for the the seats are not ready-cut from the factory.
These openings can be cut by the consumer once the mat has been installed. view full answer...
Since you were looking at the Yakima HD Crossbars # Y01158 I will assume these are the crossbars you would like for your roof rack. Although there is no separate bundle for an additional crossbar, the parts are available to make this happen.
For the roof rack with 2 crossbars you will need the # Y01158, # Y53TR, # Y03541, and two of the # Y00221. Adding the full rack to the cart will get you everything you need from these part numbers. In order to add the third bar you will need the #... view full answer...
The Tekonsha brake controller part # TK90160 with the # 3050-P install harness is a really easy to install brake controller setup for your 2016 Nissan NV 3500. The only solution similar that might have a slightly more easy install is the P3 part # 90195 since it has a wider range of mounting directions compared to the # TK90160. I would think you could knock out the install in less than 30 minutes with most of the time being picking where to mount the controller on your dash. view full answer...
It sounds like you're speaking of a mounting panel or bezel for the control knob of a Redarc # RED44FR Tow Pro Elite or # RED24FR Liberty brake controller.
If you go with the # RED44FR Tow-Pro Elite, the universal bezel is included with the controller.
If you use the # RED24FR Tow-Pro Liberty, the bezel is sold separately. I'd recommend using the # 331-TPSI-001 universal mounting panel. This bezel would work perfectly for mounting the control knob in an unused switch knockout. The panel... view full answer...
Go To Results